Ch. 1 - Angles and the Trigonometric Functions

Blitzer3rd EditionTrigonometryISBN: 9780137316601Not the one you use?Change textbook

Blitzer 3rd Edition

Ch. 1 - Angles and the Trigonometric Functions

Problem 1.1.68

Chapter 1, Problem 1.1.68

In Exercises 57–70, find a positive angle less than or that is coterminal with the given angle. -𝜋/40

Verified step by step guidance

Understand that two angles are coterminal if they differ by an integer multiple of \(2\pi\). This means we can add or subtract \(2\pi\) to the given angle to find coterminal angles.

The given angle is \(-\frac{\pi}{40}\). Since it is negative, to find a positive coterminal angle less than or equal to \(2\pi\), add \(2\pi\) to it.

Write the expression for the coterminal angle: \(-\frac{\pi}{40} + 2\pi\).

To add these, express \(2\pi\) with a denominator of 40: \(2\pi = \frac{80\pi}{40}\). So the sum becomes \(-\frac{\pi}{40} + \frac{80\pi}{40} = \frac{79\pi}{40}\).

Verify that \(\frac{79\pi}{40}\) is positive and less than or equal to \(2\pi\) to confirm it is the desired coterminal angle.

Verified video answer for a similar problem:

This video solution was recommended by our tutors as helpful for the problem above.

Video duration:

Was this helpful?

Key Concepts

Here are the essential concepts you must grasp in order to answer the question correctly.

Coterminal Angles

Coterminal angles are angles that share the same initial and terminal sides but differ by full rotations of 2π radians. To find a coterminal angle, you add or subtract multiples of 2π until the angle lies within the desired range, such as between 0 and 2π.

Angle Measurement in Radians

Angles can be measured in radians, where 2π radians equal 360 degrees. Understanding radian measure is essential for working with trigonometric functions and converting between degrees and radians when necessary.

Positive Angle Determination

Finding a positive angle less than or equal to 2π involves adjusting the given angle by adding 2π repeatedly if it is negative. This ensures the angle is expressed within the standard interval for trigonometric analysis.

Recommended video:

05:50

Drawing Angles in Standard Position

Related Practice

Textbook Question

In Exercises 59–62, use a calculator to find the value of the acute angle θ in radians, rounded to three decimal places. cos θ = 0.4112

698

views

Textbook Question

In Exercises 57–70, find a positive angle less than or that is coterminal with the given angle. 17𝜋 /5

611

views

Textbook Question

In Exercises 61–86, use reference angles to find the exact value of each expression. Do not use a calculator. tan(-𝜋/4)

753

views

Textbook Question

In Exercises 41–56, use the circle shown in the rectangular coordinate system to draw each angle in standard position. State the quadrant in which the angle lies. When an angle's measure is given in radians, work the exercise without converting to degrees.

-210°

649

views

Textbook Question

In Exercises 63–68, find the exact value of each expression. Do not use a calculator. csc 37° sec 53° - tan 53° cot 37°

595

views

Textbook Question

In Exercises 75–78, find the area of the sector of a circle of radius r formed by a central angle θ. Express area in terms of π. Then round your answer to two decimal places. Radius, r: 10 meters Central Angle, θ: θ = 18°

576

views