27. Resistors & DC Circuits

Eight identical bulbs are connected in series across a 120-V line. What is the voltage across each bulb?

Calculate the terminal voltage for a battery with an internal resistance of 0.900 Ω and an emf of 6.00 V when the battery is connected in series with a 610-Ω resistor.

A galvanometer has an internal resistance of 32 Ω and deflects full scale for a 48-μA current. Describe how to use this galvanometer to make an ammeter to read currents up to 25 A.

Calculate the terminal voltage for a battery with an internal resistance of 0.900 Ω and an emf of 6.00 V when the battery is connected in series with a 61.0-Ω resistor.

Neglect the internal resistance of a battery unless the problem refers to it. Ten 7.0-W Christmas tree lights are connected in series to each other and to a 120-V source. What is the resistance of each bulb?

Neglect the internal resistance of a battery unless the problem refers to it. Eight bulbs are connected in parallel to a 120-V source by two long leads of total resistance 1.4 Ω. If 210 mA flows through each bulb, what is the resistance of each, and what fraction of the total power is wasted in the leads?

What voltage will produce 0.25 A of current through a 5400-Ω resistor?

An electric device draws 5.25 A at 240 V. If the resistance of the device were reduced by 7.5%, what current would be drawn at the lower voltage?

A silicon diode, whose current–voltage characteristics are given in Fig. 40–38, is connected in series with a battery and an 860-Ω resistor. What battery voltage is needed to produce a 16-mA current?

(III) The filament of an incandescent lightbulb has a resistance of 12 Ω at 20°C and 140 Ω when hot. In this temperature range, what is the percentage change in resistance due to thermal expansion, and what is the percentage change in resistance due solely to the change in ρ? Use Eq. 25–5.

Household wiring has sometimes used aluminium instead of copper. Using Table 25–1, find the ratio of the resistance of a copper wire to that of an aluminum wire of the same length and diameter.

Household wiring has sometimes used aluminium instead of copper.Typical copper wire used for home wiring in the U.S. has a diameter of 1.63 mm. What is the resistance of 125 m of this wire?

Household wiring has sometimes used aluminium instead of copper. What would be the resistance of the same wire if it were made of aluminum?

A Wheatstone bridge is a type of “bridge circuit” used to make measurements of resistance. The unknown resistance to be measured, R_x, is placed in the circuit with accurately known resistances R₁, R₂ and R₃ (Fig. 26–73). One of these, R₃, is a variable resistor which is adjusted so that when the switch is closed momentarily, the ammeter shows zero current flow. (a) Determine R_x in terms of R₁, R₂ and R₃. (b) If a Wheatstone bridge is “balanced” when R₁ = 685 Ω, R₂ = 972Ω and R₃ = 78.6Ω, what is the value of the unknown resistance?

The cross section of a portion of wire increases uniformly as shown in Fig. 25–38 so it has the shape of a truncated cone. The diameter at one end is a and at the other it is b, and the total length along the axis is ℓ. If the material has resistivity ρ, determine the resistance R between the two ends in terms of a, b, ℓ, and ρ. Assume that the current flows uniformly through each section, and that the taper is small, i.e., ( b -a) ≪ ℓ.