BackA 2.0 cm×2.0 cm square loop of wire with resistance 0.010 Ω has one edge parallel to a long straight wire. The near edge of the loop is 1.0 cm from the wire. The current in the wire is increasing at the rate of 100 A/s. What is the current in the loop?
A tightly-wound 200-turn rectangular loop has dimensions of 40cm by 70cm. A constant magnetic field of 3.5T points in the same direction as the normal of the loop. If the dimensions of the loop change to 20cm by 35cm over 0.5s, with the number of turns remaining the same, what is the induced EMF on the rectangular loop?
A square conducting wire of side length 4 cm is in a 2 T magnetic field. It rotates such that the angle of the magnetic field to the normal of the square increases from 30° to 60° in 2 s. What is the induced current on the wire if its resistance is 5 mΩ?
A long, straight solenoid with a cross-sectional area of 8.00 cm2 is wound with 90 turns of wire per centimeter, and the windings carry a current of 0.350 A. A second winding of 12 turns encircles the solenoid at its center. The current in the solenoid is turned off such that the magnetic field of the solenoid becomes zero in 0.0400 s. What is the average induced emf in the second winding?
The magnetic field B at all points within the colored circle shown in Fig. E29.15 has an initial magnitude of 0.750 T. (The circle could represent approximately the space inside a long, thin solenoid.) The magnetic field is directed into the plane of the diagram and is decreasing at the rate of -0.0350 T/s. If the ring is cut at some point and the ends are separated slightly, what will be the emf between the ends?
<Image>
The magnetic field B at all points within the colored circle shown in Fig. E29.15 has an initial magnitude of 0.750 T. (The circle could represent approximately the space inside a long, thin solenoid.) The magnetic field is directed into the plane of the diagram and is decreasing at the rate of -0.0350 T/s. What is the shape of the field lines of the induced electric field shown in Fig. E29.15 , within the colored circle?
<Image>
A long, thin solenoid has 400 turns per meter and radius 1.10 cm. The current in the solenoid is increasing at a uniform rate di/dt. The induced electric field at a point near the center of the solenoid and 3.50 cm from its axis is 8.00 × 10-6 V/m. Calculate di/dt.
A long, thin solenoid has 900 turns per meter and radius 2.50 cm. The current in the solenoid is increasing at a uniform rate of 36.0 A/s. What is the magnitude of the induced electric field at a point near the center of the solenoid and (a) 0.500 cm from the axis of the solenoid; (b) 1.00 cm from the axis of the solenoid?
The magnetic field within a long, straight solenoid with a circular cross section and radius R is increasing at a rate of dB/dt. What is the magnitude of the induced emf if the radius in part (d) is 2R?
The magnetic field within a long, straight solenoid with a circular cross section and radius R is increasing at a rate of dB/dt. What is the magnitude of the induced emf in a circular turn of radius R/2 that has its center on the solenoid axis?
A metal ring 4.50 cm in diameter is placed between the north and south poles of large magnets with the plane of its area perpendicular to the magnetic field. These magnets produce an initial uniform field of 1.12 T between them but are gradually pulled apart, causing this field to remain uniform but decrease steadily at 0.250 T/s. What is the magnitude of the electric field induced in the ring?
The conducting rod ab shown in Fig. E29.29 makes contact with metal rails ca and db. The apparatus is in a uniform magnetic field of 0.800 T, perpendicular to the plane of the figure. In what direction does the current flow in the rod?
A flat, rectangular coil of dimensions l and w is pulled with uniform speed v through a uniform magnetic field B with the plane of its area perpendicular to the field (Fig. E29.14). (a) Find the emf induced in this coil. (b) If the speed and magnetic field are both tripled, what is the induced emf?